The light fixture instructions may also give you guidance on the proper way to attach the mounting strap.
Ceiling light fixture installation instructions.
Securing the fixture screw the ceiling plate to the mounting strap or support rod then put the mounting stem onto the ceiling plate.
Align the head of the screw into the wider part of the hole and twist the fixture to the narrower part.
Some of these wires may be wired to different circuits than the.
Most light fixtures will have a keyhole shaped hole.
Secure the new fixture and adjust length if there s a chain.
How to install a ceiling light fixture step by step leah from see jane drill demonstrates how to easily remove a.
If you just have a small green screw on your mounting plate wrap the new copper wire around that.
One person should stabilize the ladder.
Move the tip of a.
Thread the light fixture s electric wires through the screw collar loop.
Turn off the power to the light fixture at the main circuit panel.
Then attach the mounting strap to the ceiling box using whatever screw holes line up with the ceiling box.
Make sure the power is off.
You may find several pairs of wires in the ceiling box.
Split the fixture wire into two for its last 6 inches you can do this by grasping the ends of the two wires and pulling them in opposite directions.
To replace a ceiling light fixture follow these steps.
How to hang a ceiling light fixture remove the old fixture and inspect the wiring.
Turn off the power.
Subscribe to our channel and like our video.
Using a wire cutter cut the length of the light fixture s.
At this point make sure that the installation is secure and.
Refer to your light fixture instructions and your individual situation.
Unscrew the screws or nuts holding the.
With the light fixture assembled attach it to the screw collar by the chain.
Remove the light bulb cover and bulbs from the fixture.
If there s a copper wire pre installed in your ceiling connect the new wire there.
Tighten the mounting screws.
If you re using a center mounted ceiling light slide the canopy onto the rod so the nipple shows through the center hole.
Remove the nut or screws securing.
Strip about 1 2 inch of plastic coating off the ends of both fixture wires.