Chain Link Fence Installation Guide

As chain link fence posts are smaller and sturdier than many other types the holes should be smaller and can be farther apart.

Chain link fence installation guide.

Step 2 with crayon or chalk mark the ground line on posts. Check out your property line setback requirements. Check all local building codes and homeowner s association guidelines for acceptable. You then dig a hole for each post deep enough to set it in concrete which is at least 2 feet for a 4 foot fence or you can dig shallower holes for post anchors an alternative to concrete demonstrated by diy landscaping.

If the rails are too. 1 the good thing is that you can dig all the post holes at once. There may be local zoning or deed restrictions pertaining to height and type of fence. Cut off excess length with a pipe cutter or hacksaw.

Mix a fairly heavy solution as too much water weakens concrete and may cause cracking. Be sure to slope the concrete away from the post to allow water to run away from the base. Measure the total length of your planned fence to determine the length of fence fabric and top rail. Follow the fence manufacturer s instructions for spacing which typically ranges from 4 10 apart spacing should not exceed 10 on center.

Add 6 inches. Mark the exact location of terminal post with a stake or spray paint. Mark the fence layout. As with any diy fence project a chain link fence installation begins with laying out the fence lines and marking the positions of posts.

6 to 8 inches for end and corner posts 4 to 6 inches for line. Dig the post holes. Terminal posts should be set 2 higher than the width of the fabric and line posts 2 lower than the fabric width. Find surveyors pins if the fence is to be located near property lines or have the lot surveyed.

Tighten nuts and bolts. The exact diameter and depth will be determined by local weather and soil conditions. Starting with one of your terminal posts set the post in the center of its hole and position it to a plumb position using a level and plumb line. Mark the layout using string.

Before you can dig post holes you need to lay out your fence area. Obtain necessary zoning and building permits. All posts should be set about 4 inches inside the line. Set the terminal posts in concrete using a concrete mix as follows.

Set your posts about 4 inches away from your property line to avoid any property line issues with neighbors. Dig post holes three times wider than the post diameter. Secure it in place and fill the hole around it with wet concrete. Feed the top rails through the loop caps.

Install the top rail 1. 1 part cement 2 parts sand and 4 parts gravel. Chain link fence installation manual before you begin. Insert the rail ends into the terminal rail caps.

11 steps of chain link fence installation locate your property s line. Fill all the holes with 4 inches of gravel and tamp.